Dry Film Lubrication for perfect surface engineering
كاتب الموضوع
رسالة
admin
المـديـر العـــام
معلومات إضافية
الجنسية : مصرى
الجنس :
عدد المساهمات : 833
إحترام قوانين المنتدى : 14
تاريخ التسجيل : 22/11/2009
العمل : مهندس ميكانيكا انتاج
المزاج : .............................
كيف تعرفت علينا ؟ : انا صاحب المنتدى
موضوع: Dry Film Lubrication for perfect surface engineering الخميس 29 ديسمبر 2011 - 22:46
Low Friction
Coatings designed for Low Friction and Dry Film Lubrication provide permanent lubrication with consistent low friction performance over the wear life of the coating. Correct coating selection coupled to appropriate bearing design ensures low friction for the life of the mechanism or machine.
There are many examples which can vary from an edge cutting tool used for tough materials, to a pedal shaft on a car where squeaks must be eliminated for life coupled with ease of actuation or a seat belt locking mechanism which must release every time despite the load applied.
The Indestructible range of Low Friction Coatings incorporates blends of solid lubricant bonded permanently to a substrate. The selection of the correct coating take account of the: -
Bearing abrasive condition
Smoothness of the mating surface
Pressure or load
Relative speed of the two surfaces
These factors are all vital to a successful bearing which should ensure the lowest possible friction and consistent lubrication for the duration of the design life of any bearing.
When bonded to either metal, plastic substrates, these coatings will extend the lifetime of components whilst eliminating annoying squeaks, chatter, fretting galling or scuffing.
Frictions in a dynamic situation causes heat, wear, and absorb energy. Bearing failure is often caused by overheating and subsequent bearing seizure. The bearing property of a dry lubricant coating has the ability to withstand high temperature without catastrophic failure through sudden melt or breakdown.
Indestructible Low Friction Coatings are based on thermosetting polymers, which withstand a wide temperature range and exceed the operating limits of most conventional mineral and synthetic oils.
تنبيه للأعضاء
مواضيع لم يرد عليها
تغذية rss
أفضل 20عضو
أفضل اعضاء اليوم
جديد المواضيع
مشـــــاركاتي
قوانين المنتدى
التسجيل
الخميس 21 نوفمبر 2019 - 12:14
موضوع: Dry Film Lubrication for perfect surface engineering 
الخميس 29 ديسمبر 2011 - 22:46
